Drawings & files
Evaluate DXF contours, STL and STEP models, G-code, and CSV files.
In short: Drawings & files
These tools evaluate manufacturing files: contour lengths and closed areas from DXF, surface area, volume and extents from STL, outer dimensions, volume, turned part, holes and pockets from the exact surface geometry of STEP files, travel paths and nominal run time from G-code, title block and tolerance callouts from the text of PDF drawings and the structure of CSV tables. They provide key figures but do not replace checking the original.
Frequently asked questions about Drawings & files
Why does an STL file need a unit?
The STL format only stores the coordinates of the triangles, not a length unit. Whether a file was exported in millimetres or inches must therefore be stated: lengths scale linearly, areas quadratically and volumes cubically. A volume can only be derived from a closed mesh without self-intersections.
How accurate is the run time from a G-code evaluation?
The evaluation divides feed paths by the programmed feed and calculates rapid moves with an assumed rapid speed. Acceleration, tool changes, spindle ramp-up and dwell times are missing, so the actual machine run time is usually longer.
What does the PDF drawing check read?
It searches the text layer of the PDF for drawing number, material, scale, threads, fits, roughness and general tolerances. Scanned drawings without a text layer and purely graphical dimensions are not read; every finding must be compared with the original drawing.
How exact are the dimensions from a STEP file?
The evaluation works with the exact surface geometry of the solid, including cylinders, cones and free-form surfaces, in the length unit of the file. The outer dimensions are axis-parallel in the coordinate system of the file and without stock allowance. Without a declared unit, with open geometry or with several bodies, a note says which value stays open. Detected holes and thread candidates are proposals and must be compared with the drawing before use.