General Geometrical Tolerances to ISO 2768-2
Free ISO 2768-2 geometrical tolerance calculator
Reads designations such as ISO 2768-mK and shows the general geometrical tolerances of classes H, K and L for straightness, flatness, perpendicularity, symmetry, run-out, roundness and parallelism.
How to use the result
How to read ISO 2768-mK: “m” is the medium class for linear and angular dimensions under ISO 2768-1, “K” the medium class for geometrical tolerances under ISO 2768-2. H is fine, L coarse. An appended “-E” additionally requires the envelope requirement for all single features of size. Designations without an upper-case letter, such as ISO 2768-m, define no general geometrical tolerances.
Flatness example: an 80 mm long surface lies in the range over 30 to 100 mm; in class K its flatness tolerance is 0.2 mm. The same surface in class H may deviate by 0.1 mm.
Roundness example: a 25 mm diameter to ISO 2768-mK has a deviation of ±0.2 mm, i.e. a size tolerance of 0.4 mm. Roundness equals the size tolerance but is at most the class K run-out tolerance of 0.2 mm, so 0.2 mm.
Parallelism: the larger of the distance size tolerance and the straightness or flatness tolerance applies. The longer of the two features is the datum.
Perpendicularity and symmetry: the longer leg or feature is the datum, the shorter one is toleranced. With equal lengths either may serve as the datum. Perpendicularity also applies to undimensioned 90° angles.
Run-out: the general tolerance for circular radial, axial and total run-out is 0.1 mm in H, 0.2 mm in K and 0.5 mm in L. The datum is the surfaces designated as bearing surfaces, otherwise the longer feature.
ISO 2768-2 does not specify coaxiality or concentricity; in the extreme case the deviation may be as large as the run-out tolerance. Cylindricity has no own value: it consists of roundness, straightness and parallelism of the generator lines, each limited by its own or a general tolerance. There is no general position tolerance; location deviations follow from the size tolerances of the coordinate dimensions. A tight position needs its own tolerance frame.
What applies when no general tolerance is indicated? Then no general geometrical tolerances apply either: ISO 2768 only takes effect through a note in the title block. Clarify missing indications with the customer before quoting and manufacturing. For drawings under the newer GPS system, ISO 22081 describes general geometrical specifications.
Formulas
Straightness, flatness, perpendicularity, symmetry: table value by class and nominal length rangeRoundness = min(diameter size tolerance; run-out tolerance)Parallelism = max(distance size tolerance; straightness or flatness tolerance)Size tolerance without an individual indication = 2 · deviation to ISO 2768-1 Sources: ISO 2768-2:1989 (DIN ISO 2768-2:1991): General tolerances; geometrical tolerances for features without individual tolerance indications, Tables 1 to 4 and clause 5.; ISO 2768-1:1989 (DIN ISO 2768-1:1991): permissible deviations for linear dimensions, Table 1.; ISO 1101:2017: Geometrical product specifications; tolerances of form, orientation, location and run-out.