CNC Calculator

Convert Ra, Rz and Rt for free

Estimates Rz from Ra or Ra from Rz with an assumed ratio, states the lower limit for Rt and converts Ra to microinches.

Continue calculating

How to use the result

Ra is the arithmetic mean of the profile deviations, Rz the mean of the single peak-to-valley heights from several sampling lengths, and Rt the largest profile height over the whole evaluation length. The parameters describe different properties of the same profile; there is no fixed conversion between them.

Rz to Ra example: Rz 10 µm gives about Ra 1.7 µm with a ratio of 6 and about Ra 2.5 µm with a ratio of 4. The spread shows why the result is only an estimate. The table in the result lists common Rz values with the selected ratio.

Your own ratio from measurements of the same process and material is the best basis. If a drawing states both Ra and Rz, both requirements apply independently and each must be measured.

Rt is always at least as large as Rz because the single peak-to-valley heights lie within the evaluation length. A single scratch or breakout raises Rt strongly, but Rz and Ra less.

Formulas

1 µin = 0.0254 µmRz estimate = Ra · assumed factorRa estimate = Rz / assumed factorRt ≥ Rz

Sources: NIST Special Publication 811, Appendix B: Conversion Factors. https://www.nist.gov/pml/special-publication-811/nist-guide-si-appendix-b-conversion-factors/nist-guide-si-appendix-b9; ISO 4287:1997 and ISO 21920-2:2021: definitions of the profile parameters Ra, Rz and Rt.

Save calculation

You need a free account to save. Your inputs remain available and will be saved after you sign in.

All features Free quotation assistant AI quote MCP Legal notice Privacy L&I IT-solutions GmbH & Co. KG in cooperation with D'Este Solutions and Bley IT

Carlo D'Este, D'Este Solutions

Help and contact

We are happy to answer your questions about the CNC Kalkulator in person.

Carlo D'Este, D'Este Solutions

Welcome to the CNC Kalkulator

Do you have questions about costing or getting started? Every question is welcome.

Questions? Give us a call!