CNC Calculator

Geometry

Bolt circles, triangles, tapers, chamfers, and programming coordinates.

All tools

In short: Geometry

The geometry calculators provide coordinates and dimensions that are often missing when programming and inspecting: bolt circles and hole patterns, triangles, tapers, chamfers, circle segments, ellipses, tangent points, polar and transformed coordinates and sine bar settings. The results are exact calculated values; rounding, zero point and direction of rotation are set by the user.

Frequently asked questions about Geometry

How do you calculate the coordinates of a bolt circle?

For n evenly spaced holes on a pitch circle diameter D, x = D/2 × cos(φ0 + i × 360°/n) and y = D/2 × sin(φ0 + i × 360°/n), with start angle φ0 and i = 0 to n − 1. Six holes on an 80 mm pitch circle are 60° apart and each 40 mm from the centre.

How do you determine the dimensions of a taper?

The taper ratio is C = (D − d) / L and the half taper angle α/2 = arctan((D − d) / (2 × L)). A taper from 30 mm to 20 mm diameter over 50 mm length therefore has a ratio of 1:5 and a half angle of 5.71°.

How do you set an angle with a sine bar?

The required gauge block height is h = L × sin α with the roller spacing L of the sine bar. For 15° on a sine bar with 100 mm roller spacing, 25.882 mm of gauge blocks are needed.

What should you watch out for with chamfer callouts?

A 1 × 45° chamfer has two equal legs of 1 mm; the inclined chamfer face is then 1.414 mm wide. At other angles the legs differ, and a dimension may refer to one leg or to the chamfer width. When in doubt, clarify the drawing callout.

All features Free quotation assistant AI quote MCP Legal notice Privacy L&I IT-solutions GmbH & Co. KG in cooperation with D'Este Solutions and Bley IT

Carlo D'Este, D'Este Solutions

Help and contact

We are happy to answer your questions about the CNC Kalkulator in person.

Carlo D'Este, D'Este Solutions

Welcome to the CNC Kalkulator

Do you have questions about costing or getting started? Every question is welcome.

Questions? Give us a call!