General Tolerances to ISO 2768-1
Free ISO 2768-1 general tolerance calculator
Shows the permissible deviations to ISO 2768-1 for linear dimensions, radii and chamfers, and angular dimensions in classes f, m, c and v.
How to use the result
General tolerances apply to every linear and angular dimension without an individual tolerance when the title block or a note refers to the standard, for example “ISO 2768-m” or “ISO 2768-mK”. The lower-case letter is the class for linear and angular dimensions under Part 1, the upper-case letter the class for geometrical tolerances under Part 2.
Linear example: 25 mm in class m lies in the range over 6 to 30 mm and may deviate by ±0.2 mm, i.e. 24.8 to 25.2 mm. The same dimension in class f may deviate by ±0.1 mm.
Chamfer example: a 0.5 mm chamfer or an R2 radius in class m may deviate by ±0.2 mm. Broken edges have their own table with only three ranges.
Angle example: a 90° angle whose shorter leg is 40 mm long may deviate by ±0° 30′ in class m, i.e. 89° 30′ to 90° 30′. At the end of a 100 mm leg this corresponds to about 0.87 mm. Right angles that are not dimensioned also fall under Part 1 as long as the drawing does not refer to ISO 2768-2; with a class H, K or L the perpendicularity tolerance of Part 2 applies to them.
No values: class v specifies no deviation for 0.5 to 3 mm and class f none for over 2000 to 4000 mm. Dimensions below 0.5 mm have no general tolerance; the deviation must be indicated next to the dimension.
What applies when no general tolerance is indicated? ISO 2768 then does not apply automatically: a dimension without an individual tolerance and without a reference to a general tolerance is not unambiguously specified. Clarify the tolerance with the customer before quoting and manufacturing instead of assuming a class. A company standard or supply agreement may specify a class.
Not covered are auxiliary dimensions in brackets, theoretically exact dimensions in a frame, and dimensions with their own tolerance or fit. Use the ISO fit calculator for fits and the ISO 2768-2 general tolerances for geometrical characteristics.
General tolerances describe normal workshop accuracy. Under ISO 2768-1, exceeding them does not automatically lead to rejection as long as the function of the part is not impaired, unless otherwise agreed.
Formulas
Maximum size = nominal size + deviation; minimum size = nominal size − deviationRanges: over the lower limit up to and including the upper limit; the first range starts at 0.5 mm inclusiveDeviation per 100 mm = 100 mm · tan(angular deviation) Sources: ISO 2768-1:1989 (DIN ISO 2768-1:1991): General tolerances; tolerances for linear and angular dimensions without individual tolerance indications, Tables 1 to 3.; ISO 8015:2011: Geometrical product specifications, fundamentals; a requirement applies only when it is indicated.