Grinding time
Free grinding time calculator
Estimates grinding time, dressing and setup for external, internal, jig, surface and centreless grinding.
How to use the result
The specific removal rate Q′w per material class is a cautious start value for corundum and CBN wheels on steel; measured times from your shop take priority.
External grinding between centres needs centre holes on the part. Without centre holes, clamp in a chuck; lapping of the centres is then not needed.
Surface grinding places several parts on one load. A large batch shares table strokes, clamping and turning over many parts; a single part carries them alone.
Centreless infeed grinding and double-disc grinding have no time model yet. Enter your measured piece time; setup and programming are added.
Formulas
t_rough = π · d · L · (a − a_finish) / (Q′w,rough · b) / 60; t_finish = π · d · L · a_finish / (Q′w,finish · b) / 60b = L for plunge grinding, else 0.5 · wheel width; t_spot = (t_rough + t_finish + t_spark-out + approach) · countSurface grinding per load: passes · cross strokes · (L_load + 2 · overrun) / table speed + approach per faceDressing = round up(batch quantity / parts per dressing) · 2 min Sources: Specific removal rates of conventional corundum and CBN grinding wheels on steel in the range 1–10 mm³/(mm·s) from general grinding handbooks; set cautiously as an assumption (start value).; Shared time-model data time-model-data-v1 of both applications (start values with source and assumption flag).