Developed length of bent parts
Free developed length calculator for bent parts
Calculates the blank length of a bent part from outside dimensions, bend angles, sheet thickness and inner radius to DIN 6935.
How to use the result
The outside dimensions are measured over the outer faces to the virtual sharp. Add the sheet thickness to inside dimensions first.
Without an inner radius, an inner radius equal to the sheet thickness is assumed. The minimum radius depends on the material, about three times the thickness for hard aluminium.
A flat pattern or bend table on the drawing is the customer’s binding statement and takes precedence over the calculation.
For bend angles above 90° (acute opening angle) DIN 6935 measures the legs to the outer tangent of the bend. For closed hems your shop’s bend table applies.
Formulas
K = 0.325 + 0.25 · lg(ri / t), limited to 0.25 … 0.5; ri / t at least 0.65 (DIN 6935: k = 0.65 + 0.5 · lg(ri/s), K = k/2)Bend allowance = π/180 · α · (ri + K · t); outside setback = tan(α/2) · (ri + t) up to α = 90°, beyond that ri + t (DIN 6935, opening angle below 90°)L_developed = Σ outside dimensions − 2 · Σ outside setbacks + Σ bend allowances Sources: DIN 6935: Cold bending of flat rolled steel products, correction factor k for the position of the neutral fibre.; Shared time-model data time-model-data-v1 of both applications (K-factor limits).